PACK NEWALP

<heading-style-h2>PACK NEWALP<heading-style-h2>

<heading-style-h6>Multi-function anchor <heading-style-h6>

Composed of a stainless plate and a ready-to-install matrix.
The matrix benefits from specific machining, allowing the cable to be oriented on each side. It is versatile and can be used both at the entry/exit of a life line and as an intermediate point.
The energy absorbed by sliding offers very low values.

<heading-style-h3>Assembly procedure <heading-style-h3>

1. Check the condition of the anchor support and the cable.
2. Proceed to place the plate on its support.
3. Position the 10 mm lifeline cable inside the aluminum matrix using the 6 bolts.

Tightening is done until the plate stops with a strong thread-locking adhesive.

<heading-style-h3>Installation advice <heading-style-h3>

Attention: the hook must be able to pass freely.
The lifespan of the material depends on the quality of the support and the environment.
A minimum check every 12 months is required.
Cable tension 300 kg

<heading-style-h3>Verification test <heading-style-h3>

700 Dan for 30 seconds