PACK MATRIX

<heading-style-h2>PACK MATRIX<heading-style-h2>

<heading-style-h6>This part allows mounting on a pole or wall when the angle is greater than 90° and the installation of 2 NEWPRO is not possible. <heading-style-h6>

<heading-style-h3>Assembly procedure <heading-style-h3>

1. Check the condition of the anchor support and the cable.
2. Install the plate on one of the following anchors: Cube, tubular posts or A.FIX
   Position the 10 mm lifeline cable inside the aluminum matrix using the 6 bolts.
   Tightening is done until the plate stops with a strong thread-locking adhesive.

<heading-style-h3>Installation advice <heading-style-h3>

The entry/exit points are always composed with a TE70 pack and a Matrix pack.
The intermediate points are composed of two Matrix packs.
Attention: the hook must be able to pass freely.
The lifespan of the material depends on the quality of the support and the environment.
A minimum check every 12 months is required.